42
Step 4
Attach the X-mount to the motor using the screws
provided with the motor and a #2 Phillips screwdriver.
Important
: Make sure to use
threadlock on the screws to prevent
them from vibrating loose.
Step 5
Install four 8-32 blind nuts into the holes drilled in the
previous step from behind the firewall. Attach the motor to
the firewall using the four motor standoffs and four 8-32 x
2
1
/
2
-inch machine screws. Use a #2 Phillips screwdriver
to tighten the screws.
Important
: Make sure to use
threadlock on the screws to prevent
them from vibrating loose.
Step 6
The weight box is attached to the fuselage using two
4-40 x 1
1
/
4
-inch socket head screws and two #4
washers. It will be necessary to add weight when
balancing your model.
Step 7
Use hook and loop tape to attach the speed control to the
side of the fuselage above the throttle servo tray. You will
need to cut an opening in the side of the fuselage to install
the switch from the speed controller if necessary.
Summary of Contents for fokker D.VII
Page 53: ...53 Building and Flying Notes ...