36
Hangar 9 Funtana 125 ARF Assembly Manual
Step 9
The last item is to make a 1/2-inch (13mm) wide slot in the
fuselage to pass the battery leads through.
Step 10
Use medium sandpaper to sand a 1/4-inch (6mm) section
of the 16
1
/
2
-inch (420mm) throttle pushrod tube at positions
that are at one end of the tube and 4
1
/
2
-inch (115mm) from
one end of the tube.
Step 11
Slide the pushrod tube in the firewall and guide it through
the fuel tank mount and alongside the receiver battery. The
amount of tube forward of the firewall should measure
1/16-inch (1.5mm). Use medium CA to glue the tube to the
firewall and the fuel tank mount.
Step 12
Use side cutters to trim the tube at the forward edge of the
throttle servo.