11
Radiator cap and coolant reservoir
The reservoir is located inside the
hood.
The radiator is located under the
cover plate at the rear of the hood.
Warning!
Do not open the radiator cap
abruptly while water’s temperature is
higher than 70
℃
. Turn the cap a little to
the left to relieve the pressure in the
pressure in the radiator, and then remove
the cap.
Do not wear glove when removing
radiator cap.
The antifreeze fluid is dangerous
for your health, if touched to skin, please
wash clean by water. Do not allow
children access to antifreeze.
Fork stopper
It’s used to adjust fork spacing and
to lock the forks in position. Pull up fork
stoppers, turn 90
°
, according to loads
to handle the forks spacing.
Warning!
The forks should be set symmetrically
to machine centerline and fork stoppers
should always be set.
The lower beams of fork have a hatch
to load or unload forks.
The fork is forbidden to fix on the
location where the hatch locates. Check
the bolt at the middle of the fork bracket
which is used to prevent load fork at the
hatch.
Steering column tilting angle
adjustment
The tilting angle of the steering wheel is
adjustable to suit individual operators.
The steering column is unlocked by
pushing down the lever at the left side of
turning rod, then adjust the angle suit to
the driver, and pull up the lever to lock.
Caution:
a. After stop the truck and pull on the
parking brake lever then to adjust the
tilting angle of steering column.
b. After adjust the angle and pull the
steering wheel to make sure tighten the
lock rod.
Safety step and safety grip
The safety steps are provided on
both sides of the truck body. The safety
grip is provided on the front left pillar of
the overhead guard. Use the safety step
and safety grip facing the truck when get
on and get off the truck.
