26
4) Dismantle the oil filter by tool.
5) Use cloth clean the surface of oil
filter.
6) Lay on little oil on the rubber ring of
new oil filter.
7) Install new oil filter by hand,not
spanner.
8)Referrence <<Table for the oil used in
the truck>>,oil preferred.
9)Start the engine,check leak oil around
oil tuck and filter.
If leak obviously,this part is wrong
install.
10)
Warm-up engine enough,then
flameout,check oil level later.fill if
need.
Check the oil fluid surface,put the truck
at ground flatly.
2.Plus lubricate to front and rear of
pin
roll of Tilt cylinder
Clean the plus place,pile out the past oil.
3.Check the gear oil of drive Axle
housing
If there is more dust at work place, after
200 hours use, it need consider that
change the gear oil of drive axle
housing.
4. Change transmission oil filter
Check the hydraulic transmission oil
fluid, if more dust, change the
hydraulic oil of transmission. It is first
time.
Let the truck at level ground,
play-down the fork to floor, inclined back
the mast, strain brake handle, when
transmission is at neutral position, engine
is cut off.
△
!
Caution
Hot hydraulic oil and part will hurt
Body. Do not touch the hot hydraulic
oil and part.
1)
Dismantle rubber mat and front
soleplate.
2)
Dismantle filter, deal with
located statute.
3)
Clean pedestal of filter, confirm
that the old gasket of pedestal have
be cleaned.
4)
Plus less hydraulic oil on the new
filter gasket.
5)
Install filter by hand. When the
filter get to pedestal, screw down
1/2-3/4 laps.
6)
5.Change hydraulic transmission
oil(first time, then semiannually)
Let the truck at level ground, play-down
the fork to floor, inclined back the mast,
strain brake handle. When transmission is
at neutral position, engine is cutoff.
△
!
Caution
Hot hydraulic oil and part will hurt
Body. Do not touch the hot hydraulic
oil and part.
1) Put one case(cubage is over 20 litre)
under the transmission.
2) Dismantle oil tuck,put oil in it.
