30
Other
1. Fuse and relay
The fuse box is at middle of instrument
and nearside of steering wheel. Before
replace a new one fuse, please find out
the cause of problem at first.
Please replace the same capacity fuse.
See “fuse and relay” on page 16.
.
2. The change of tyre
△
!
Warning!
When using an air compressor, first
adjust the air pressure of the
compress-or. Failure to do so will cause
a serious accident, since the compressor
delivers the maximum pressure.
To make sure safe, put the tyre in a
defend casing when charge.
Front wheel
1) Place lift truck on level concrete.
2) Start engine and raise carriage about
100mm height.
3) Place chocks behind rear wheels to
prevent movement of forklift.
4) Loosen wheel nuts 1-2 turns each by
turning them counter-clockwise.
5) Tilt mast fully backward, and place a
wooden block under each side of outer
mast.
6) Tilt mast forward until front tires are
raised from surface.
Caution:
Do not allow loose nuts before the
front wheels leave away from the ground.
7) Support forklift truck by putting
additional wooden blocks under each side
of the front-end frame as shown below.
Stop the engine.
8) Take out the wheel nut and replace
the front wheel tire.
Warning!
a. When removing tire from wheel rim,
do not remove rim set bots and nuts
before releasing air.
b. Make sure that wooden blocks used
to support lift truck are solid, one-piece
units.
c. Never get under forklift while it is
supported only by wooden blocks.
9) Retighten
the
wheel nut temporarily.
10) Start the engine, and take out the
wooden block.
11) Tilting backward the mast and lower
down the mast slowly, then take out the
wooden block under the outer mast and
rear wheel.
12) Retighten the wheel nut with right
tightens torque.
13)
Inflation tyre again to right air
pressure.
