4
Hour meter [1]
This meter measures working time
of engine. Use meter to schedule
lubrication and maintenance periods.
Water temperature gauge [2]
This gauge indicates the oil
temperature in the torque converter
transmission box. In normal status, the
pointer is in green zone. (60~115
℃
)
Caution
If the pointer points red zone, please stop
the truck at once. Decrease the engine speed
to make the engine cool. Check the cooling
fluid if enough and the fan belt’s elasticity if
fit.
Fuel gauge [3]
The gauge indicates the fuel level in the
tank when the key is at
(ON) position.
┃
Charge (A)
This lamp indicates the battery
condition of charge. The lamp comes on
when the ignition switch is set at “ON”,
but it goes out as the engine starts and
accelerator pedal is pressed.
Caution
If the light continues to stay lit or
lights up during operation, the charging
rate is low and should be checked
immediately.
Oil pressure alert lamp (B)
This lamp indicates the pressure
condition of engine lube oil. Although it
lights up when the engine switch is set at
“ON”, once the engine starts up and the
accelerator pedal is pressed, this lamp
goes out.
Caution
If this light continues to stay lit or
lights up during operation, the pressure
is lower than 0.05Mpa and should be
checked immediately.
Glow indicator (C) [Diesel truck]
Turn the key to “ON” position and
the indicator lights up for a moment.
After the indicator goes out, turn the key
to . “Start” position
Sedimentor indicator (D) [Use in W9
、
W13
、
W15A diesel truck]
In normal state, once the starter is
set to “ON” position, this lamp
lights up. After the engine is started up,
it goes out.
This lamp lights up when water in
sedimentor reaches to a certain level,
while the engine is running.
If this lamp continues to stay lit or
lights up during the engine running,
stopping the engine and discharge water
immediately.
Caution
Fuel injection pump will be damaged
if continue working when the light is up.
Engine coolant temperature [E]
In normal state, once the starter is
set to “ON” position, this lamp
lights up. After the engine is started up,
it goes out.
During work time if the oil
temperature exceed the normal
rang(60~120
℃
) the indicator light on.
Caution
If the pointer enters the red range,
stop the operation instantly and slow
down engine speed to cool the coolant
and wait until the pointer goes into the
green range, and have a check then.
