21
Depress the pedal partially to decrease
hydraulic oil pressure. Use inching pedal for
forklift loading and unloading, and when slow
speed is required. When pedal is depressed
all the way, forklift will slow to a stop.
Caution
Do not use the inching pedal too much, as it
will cause transmission oil temperature to
rise and the clutch to slip.
Emergency disconnect switch [14]
Press the emergency disconnect switch,
disconnect electrical appliance with battery.
Re-start the truck, pull up the switch.
After shut down, turn off the switch in 30
seconds.
Parking brake lever [15]
Pull lever backward to set the parking brake,
push lever forward to release the parking
brake. Always set parking brake before
leaving the truck.
Caution
In case of brake system doesn‘t work or
there is an emergency, you can tighten this
lever to stop the truck in urgency.
Normally it is prohibited to use parking
brake as service brake.
Steering column tilting angle adjustment
[16]
The tilting angle of the steering wheel is
adjustable to suit individual operators. The
steering column is unlocked by pushing down
the lever at the left side of turning rod, then
adjust the angle suit to the driver, and pull up
the lever to lock
.
Caution
a. After stop the truck and pulled up the
hand brake, then adjust steering wheel
angle.
b. After adjustment, pull the steering
wheel to make sure if locked.
Reversing lever [17]
It‘s installed on the left of the steering column.
These series forklift trucks are electronic
reversing, push or pull this lever to realize the
following functions
：
(Two-wheel drive rough terrain forklift
truck)
F2
Forward 2 gear
F1
Forward 1 gear
N
Neutral
R
Reverse
