52
VI. Operation
Warning
Before operating the truck, check all
controls and warning devices for proper
operation. If any damage of fault is found,
don‘t operate truck until corrected.
1. Start-up
Starting diesel engine truck
①
Shift levers in neutral position.
②
Screw the starting switch to
position, after start, the key rebound to
┃
position.
Caution
·If it does not work within 5 seconds, screw to
―
O
‖ position and restart after 2 minutes.
·If you can‘t start for three times, please
check the reason.
Caution
When the temperature is lower than -5
0
C,
you should switch the key to
―
┃
‖ for
preheating, and start when the preheat
indicator turns off.
Starting gasoline engine
①
Shift levers in neutral position
②
Cold engine
Pull out the choke button fully. Depress
the accelerator pedal to the floor two or three
times and release it. With your foot OFF the
pedal, crank the engine by turning the ignition
key to ―START‖. Release key when engine
starts.
③
Warm engine
Do not pull out the choke button. Press
down the accelerator pedal halfway and cold
crank the engine by turning the ignition key to
―START‖. Release key when engine starts.
Caution
When the heat engine starts, do not step
the accelerator pedal to the end, cause it
may cause start trouble, even step the
pedal for several times.
Caution
The time to start should be less than 5
seconds each attempt, and the interval
between attempts should be at least 2
minutes.
After engine has started
①
Warm-up the engine for 5 minutes
②
Check engine running condition
Caution
After starting the diesel engine, accelerate its
speed to the range of 1800-2000r/min, and
warm it without work.
·
Check the compression (misfire) noise.
·
Check exhaust condition.
·
Make sure all indicators turn off.
·
After complete warming up of engine,
operate control valve lever in whole
course for 2-3 times, and check mast
working condition.
2. Travel
①
Hold the knob on the steering wheel
with your left hand and get the right hand
ready for the controls, lightly putting it on the
wheel.
②
Set the bottom of the fork 15 to 20 cm
above the ground and fully tilt back the
upright.
③
Check the safety around the machine
and give a signal when starting the engine.
Hydraulic drive forklift
·
Step the brake pedal and operate F-R
Reversing switch.
