35
Steering
D
W
M
T
S
Y
1
Test electric steering and its components.
2
Check tiller recuperating function.
3
Bearing lubrication
Electrical system
D
W
M
T
S
Y
1
Test warning and safety devices in accordance with operating
instructions
2
Test the displays and controls.
3
Check the function of micro switch and sensor.
4
Test cable and motor attachments.
5
Check contactors and/ or relays.
6
Check fuse ratings.
7
Check electric wiring for damage. Make sure wire connections are
secure.
8
Check the carbon brushes, replace if necessary.
Hydraulic system
D
W
M
T
S
Y
1
Test hydraulic system.
2
Check that hydraulic ports, hose and pipe lines are secure, check for
leaks and damage.
3
Check cylinders and piston rods for damage and leaks, and make sure
they are secure.
4
Check hydraulic oil level and top up if necessary.
5
Test relief valve and adjust if necessary.
6
Lubricate the truck according to the lubrication schedule.
7
Replace the hydraulic oil after 2000 service hours/ biannually.
Lifting assy
D
W
M
T
S
Y
1
Check link mechanism for tension, damage or rust
2
Check if there is abrasion between shaft and bearing of front and rear
fork.
3
Check if there is deformation or fracture on the upper and down
connecting rod.
4
Check if there is crack or fracture on front fork or rear fork.
5
Check for looseness of each joint.
6
Add lubricating grease to the pin roll.
Summary of Contents for Mini Series
