67
times, and tilt the mast forward/backward 3 -
5 times.
Refill it with hydraulic oil to the specified line.
30
65
40
50
60
6.7 Others
1. Tire replacement
When the tire wears down to the limit or becomes
damaged, it should be replaced promptly. Check
the wheel nuts for any looseness after the
replacement tire has run for ten hours.
Warning
When using an air compressor, as the
maximum output pressure of the air
compressor is higher than the specified
pressure of tire, the pressure setting should
be adjusted first; otherwise it may cause a
serious accident.
In order to ensure safety, the tire should be
placed in a protective frame during air
inflation.
Front wheels
1) Park the forklift on level and solid ground;
2) Start the forklift truck and lift the mast by
about 100 mm.
3) Place wooden blocks behind the rear wheels
to prevent the forklift truck from moving;
4) Loosen each wheel nut 1 - 2 turns
counterclockwise.
5) Tilt the mast backward and place wooden
blocks at the sides of the outer mast;
6) Tilt the mast forward until the front wheels are
lifted off the ground;
Caution
Do not loosen the nuts until the front
wheels have been lifted off the ground.
7) Place wooden blocks on each front side of
the forklift truck frame to support the forklift
truck and then stop the forklift truck.
8) Remove the wheel nuts and replace the
front wheels.
Caution
a. When removing the tire from the hub,
the rim bolts and nuts should not be
removed until the tire has been deflated.
b.The wooden blocks should be solid and
strong enough.
c. When the forklift is only supported with
wooden blocks do not lay under it.
9) Put on the nuts in sequence as shown in the
diagram and lock them temporarily.
10) Start the forklift truck and remove the
wooden blocks from the forklift frame.
11) Tilt the mast backward so that the forklift
truck is slowly lowered, and then take out the
wooden blocks under the mast and at the
rear wheels.
12) Tighten the tire bolts symmetrically and
crosswise in sequence.
13) Adjust the tire pressure to the specified
value.