18
Head lamp
Disassembly and assembly of the head
lamp
1. Dismantle the decorative frame;
2. Screw the four bolts at the back of the
lamp housing and open the lamp housing;
3. Cut the lead wire, loosen the lock button,
remove the lamp, change a new lamp and
install;
4. Loosen the two fixed bolts of the width
lamp, take out the lamp, check if the lamp
is damaged. If it is, then, cut the lead-out
wire close to the welding spot, change the
new plate, weld again in the original place
and install;
5. Rotate the turn light according to the
arrowhead in the back of lamp holder in
opposite direction. Take out the light,
change a new one and install;
6. Close the lamp housing, screw the bolt
and fasten up the decorative frame.
Rear combination lamp
Take apart the rear combination lamp from the
overhead guard, pay attention to the safety
1. Take the whole rear combination lamp to
the service place, take off the lamp housing,
and screw off the four bolts at the back of the
lamp housing
2. Take off LED plate, loosen two bolts fixed
the connector, cut the connector, and change
a new LED plate.
3. The installation procedure is contrary to the
disassembly.
