46
5
End Flight
Note
The chapter is going to introduce the operation steps after aircraft landing in details.
Please operate according to the following flows to make sure normal application for the next time. Some of
the operations are not necessary, please select according to the actual situation.
End Flight
Turn off power
↓
Take out batter
↓
Dismantle airborne equipment
↓
Fold aircraft
↓
Fold image transmission antenna
↓
Take out other components
5.1
Cleaning after work
The spray pipe line should be cleaned immediately after spraying operations.(details: tank is filled with
soapy water, Manually turn on the spray switch, Until Clean water flows out when the pesticide is cleaned.)
The tank and Filling equipment clean residual pesticide (details: tank is filled with soapy water, then
repeatedly shake tank. Manually turn on the spray switch, Until Clean water flows out when the pesticide is
cleaned, Then rinse with water again.
Clean the aircraft, wipe the remaining pesticide on the aircraft shell, inspect the air frame structure, replace the
damaged pipes, check the tightness of the screws to eliminate the hidden dangers, and minimize the risk factor
of the flight.
If Long term non-use, store the aircraft in: clean, ventilated, away from high temperatures.
5.2
Maintenance
After work season, inspect the components of the aircraft (if the spray piping is obviously worn, replace it in
time).
Check the updated of aircraft module and update it in time
Check the Badly Damaged battery ,and return to the factory for repair in time .
Repair the aircraft and prepare for the next operation After work season.
Summary of Contents for 3WD4-QF-10B
