a) Reset
By pressing the START/ STOP and MODE buttons at the same time, all
times and memories are erased. The daytime remains in memory.
b) MODE (changing functions)
By pressing the MODE button, the functions are changed in the
following sequences and can be seen on the display.
SPLIT -> LAP -> TIME and back to Split.
c) Measuring times
- The MODE button selects the functions SPLIT, LAP or TIME.
- Regardless which mode you have selected, it is possible to change
the mode at any time without affecting the other functions. The
function symbol on the display only confirms the time measurement
visible in the moment, while the other functions are still active in the
background.
- The START/STOP button alternately starts and stops the watch. The
symbols
confirm this procedure. The SPLIT/LAP button
causes the current SPLIT and LAP time to be memorized. The time
display stops.This serves for better recognition of the measured time.
d) Memory recall
- Memory can be recalled at any time during the time measurement
using the MEMORY button. The first 24 memories are stored for the
first 24 times. The last (25th) memory always contains the last
measured time, if more than 25 times have been stopped.
- Procedure:
Press and hold the MEMORY button. The memory time will be
indicated as long as the key is pressed. During this phase, the display
shows the MEMORY and the memory number. Pressing MEMORY
twice causes the next memory time to be emitted. The display shows
the last measured time. If the measured time should permanently be
displayed, read the next point.
12
