Hanlong Technology Co., Ltd Unicorn 60x0 User Manual Page 14 of 25
Firmware
1.0.0.29 Last Updated 8/2010
Upgrade Via->TFTP), HTTP Server IP address(if you
select Upgrade Via->HTTP)
Option 150--TFTP server address.(if you selectUpgrade
Via->TFTP), HTTP server address(if you select
Upgrade Via->HTTP)
Authenticate Conf File
configure file would be authenticated before acceptance
if set to Yes
NTP server
This parameter defines the URI or IP address of the
NTP server which is used by the Unicorn 600x to set the
current date/time.
Allow DHCP Option 42
to override NTP server
If set
Yes
,device can get NTP server from DHCP option
42.
Syslog Sever
The IP address or URL of System log server. This
feature is especially useful for the ITSP (Internet
Telephone Service Provider)
Syslog level
Default is blank, the feature is useful for the Internet
Telephone Service Provider.
Download Device
Configuration
User can download configuration from the web page
and save to configuration file.
Call Progress Tones
Using these settings, users can configure tone
frequencies and cadence according to their preference.
By default they are set to North American frequencies.
Configure these settings with known values to avoid
uncomfortable high pitch sounds. ON is the period of
ringing (“On time” in ‘ms’) while OFF is the period of
silence. In order to set a continuous tone, OFF should
be zero. Otherwise it will ring ON ms and a pause of
OFF ms and then repeat the pattern.
Example configuration for N.A. Dial tone:
f1=350@-13,f2=440@-13,c=0/0;
Syntax: f1=freq@vol, f2=freq@vol,
c=on1/off1-on2/off2-on3/off3; [...] (Note: freq: 0 -
4000Hz; vol: -30 - 0dBm)
Restore
Configuration
User can restore the before configuration from the
configuration file saved at local pc
5.3.2 Profiles
Profiles are basically IP PBX / SIP Server configuration templates. If you have more than
one IP PBX system or SIP Server that you would like to use with the Unicorn 60x0, then
you can configure Profile 1 or 2. Note – Make sure you select the correct profile for each
channel under Channels WEBPAGE.
