20
Fully tighten the stabiliser lower bolts
Fig.7
Figure 7
Measure the PTO shaft and cut to the
dimension shown
– the finished length
of the PTO shaft should be 75mm (3”)
less than the measured distance ‘
A
’ -
between tractor shaft and gearbox
stub shaft - to enable fitting.
Fig.8
NOTE:
For subsequent use with different
tractors measure again, there must be
a minimum shaft overlap of 150mm
(6”).
Fit PTO in position and attach the
torque chains to a convenient location
to prevent the shaft guards from
rotating.
Fig.9
Figure 8
Figure 9
