24
STORAGE
If machine is to be left standing for an extended period of time, lightly coat the exposed
portions of the ram rods with grease. Subsequently this grease should be wiped off before
the rams are next moved.
If the machine has to be stored outside tie a piece of tarpaulin or canvas over the control
assembly, do not use a plastic fertilizer bag which could lead to rapid corrosion.
SUBSEQUENT ATTACHMENT TO IDENTICAL TRACTOR
Refer to and follow steps on
‘initial attachment to tractor’
(page 13)
Connect Stabiliser into tractors top hitch position used previously.
Raise the machine on the tractor linkage until the Stabiliser contacts the
eccentric stops.
Fit Stabiliser lower pins.
Mount controls in the tractor cab.
Fit PTO Shaft and attach torque chain to a convenient point to prevent the shaft guard
rotating.
Place arms in work position at half reach and adjust lift arm leveling box to bring
frame horizontal.
Tighten Check Chains if fitted.
Stow parking legs.
Fold machine into transport position
(see page 36).
Proceed to the work site.
SUBSEQUENT ATTACHMENT TO DIFFERENT TRACTOR
Remove Stabiliser and Top Link from machine and separate.
Refer to and follow steps
‘initial attachment to tractor’
(page 13)
