27
26
Chapter 6 - PARAMETER SETUP MENU
From the main menu, use the arrow keys to
highlight
Parameter Setup
and then press
Select
.
The following options will be displayed:
6.1 SELECT PARAMETERS
Use the
ARROW
keys to scroll through the menu.
Press the right softkey to enable or disable a single
parameter, or the left softkey to enable or disable
all parameters. A checked box means that the
parameter is enabled.
Only the available parameters are present in the
list.
Note
If the password protection is enabled, you will be required to enter
the password before any parameters can be modified.
6.2 PARAMETER UNITS
6.2.1 Temperature Unit
The user can select the measurement unit: °C, °F
or K. The default value is °C.
6.2.2 TDS Unit (HI 98194, HI 98195 only)
The user can select ppm - ppt or mg/L - g/L
measurement unit. The default value is ppm - ppt.
6.2.3 DO Concentration Unit (HI 98194)
The user can select ppm or mg/L. Dissolved Oxygen
concentration is calculated using % saturation,
conductivity and atmospheric pressure. The default
value is ppm.
6.2.4 Pressure Unit
The user can select one the following measurement
units: psi, mmHg, inHg, mbar, atm, kPA. The
default value is psi.
5.4 SETUP MENU STRUCTURE
