HANNspree GT series, User Manual

III

English

•  The openings should never be covered with a cloth or other material, and the bottom openings 

should not be blocked by placing near or over a radiator or heat source.

•  This Television equipment should be operated only from type of power source indicated on the 

marking label. If you are not sure of the type of power supplied to your home, consult your tele-

vision dealer or local power company .

•  As a safety feature ,this television equipment  is equipped with a grounded power plug, If the 

plug does not fit in your power outlet ,contact your electrician .Do not modify the plug and de

-

feat this safety feature .

•  Do not allow anything to rest on the power cord .Do not locate this television equipment where 

the cord may be damaged due to lightning and power-line surges.

•  Follow all warnings and instructions marked on the television equipment .

•  If an outdoor antenna is connected to the television equipment ,be sure the antenna system is 

grounded so as to provide some protection against  voltage surges and static charges.

•  For added protection for this television equipment during a lightning storm, or when it is left un

-

attended and unused for long periods of time ,unplug it  from the wall outlet and disconnect the 

antenna .This will prevent damage to the equipment due to lightning and power-line surges.

•  an outdoor antenna system should not be located in the vicinity of overhead power lines or 

other electric light or   power circuits ,or where it can fall into such power lines or circuits. When 

installing an outdoor antenna system ,extreme care should be taken to keep from touching 

such power lines or circuits as contact with them might be fatal.

•  Do not over load wall outlets and extension cords as this can result in fire or electric shock.

•  Never push objects of any kind into this television equipment through cabinet slots as they may 

touch dangerous voltage points or short-circuit internal parts .This could result in a fire or elec

-

tric shock .Never spill liquid of any kind in the television equipment .

•  Do not attempt to service this television equipment yourself as opening or removing covers may 

expose you to dangerous   voltage or other hazards .Refer all servicing to qualified service 

personnel.

•  Unplug this television equipment from the wall outlet and refer servicing to qualified service per

-

sonnel under the following conditions:

— When the power cord or plug is damaged or frayed.

— If liquid has been spilled into the television equipment.

— If the television equipment does not operate  normally by following  the operating instruc-

tions. Adjust only those control that are covered by the operating  instruction as improper 

adjustment  of other controls may result in damage and will often require extensive work 

by a qualified technician to restore the television equipment to normal operation .

— If the television equipment has been dropped or the cabinet has been damaged.

— When the television equipment exhibits a distinct change in performance —this indicates a 

need for service.

•  UP on completion of any service or repairs to this television equipment ,ask the service techni

-

cian to perform routine safety checks to determine that the television is in safe operating con-

dition .

•  When replacement  parts are required ,make sure that the service technician has used replace

-

ment parts specified by the manufacturer that have the same characteristics as the original 

part. Unauthorized substitutions may result in fire ,electric shock ,or other hazards .

•  Note to CATV system installer: This note is to remind the CATV system installers 

that the cable ground shall be connected to the grounding system of the building, as 

close to the point of cable entry practical.

CAUTION:         IF the set is not going to be used for a long period ,such as during a vaca

-

tion, unplug the set from the wall outlet to economise power.  (If the TV 

set is plugged in, a slight current still flows, even with the power but

ton in 

OFF position)