14
Other:
①
Water tank is full.
A: Please unscrew the drain cap (12) located on the back of the unit and let out the water. (Refer Page 5.Fig.B)
B: After draining out all the water from the outside water tank, reconnect unit to power and it will continue
to run normally.
C: If DRAIN PUMP MODE is chosen, check that the pump water outlet switch is in the ON position. If it is
in the correct position, but still get a WARNING ALARM after you power off the unit, please contact a
service center.
D: If MANUAL DRAINAGE SYSTEM MODE is chosen, the outside water tank will be full with water
within one or two weeks according to different ambient temperatures. Please drain out the water.
②
Ice maker low on water
A: Please check if outside water supply is functioning normally. Please see CHECKING THE WATER SUPPLY box
above.
B: The icemaker will remove faults automatically within 30 minutes and work normally when outside water
pipe is functioning.
C: Press
button and turn on the unit again if icemaker does not function normally after 30 minutes.
D: If the icemaker still shows a WARNING ALARM after the above process is repeated, please contact the
service center.
③
Sensor breakdown.
A: Please contact our authorized service center to maintain.
④
BUCKET FULL alarm.
A: Check if the ice bucket is full. If so, remove the ice, and the alarm will stop.
B: If the ice bucket is not full when the alarm sounds, check to see if the ice maker cover plate is stuck. Clear any
obstruction and replace the cover and the alarm will stop.
C: When there is insufficient water supply, the ice maker cover plate may stick and the bucket full alarm will
sound. Remove any ice from around the cover plate, check that the water supply is sufficient and the
alarm will stop.
Checking the water supply
1.
Turn off water supply.
2.
Disconnect line from the icemaker.
3.
Position water supply line in a bucket.
4.
Turn on water and make sure water fills in the bucket.
