LIGHTING INSTRUCTIONS
1. Locate the control and igniter panel. Make sure the control knob is in the “OFF” position. See Fig.
1
1
. Open the tank door and open the tank valve all the way.
2. Push in the igniter button. You will hear a slight clicking sound. With the igniter button pushed in,
push and turn the control knob to the “ON” position. The fire should light within
a few seconds. Once the flame is lit, release the igniter button and continue to hold the control
knob in for 10 to 15 seconds. Release the control knob. The control knob should pop back out and
the fire should remain lit. Note: If the fire does not light, turn the knob to the “OFF” position and
wait five (5) minutes before trying again.
3. To turn down the flame, push the control knob in slightly and turn to the Medium (medium flame)
or Low (small flame).
4. To shut down the fire pit, turn the control knob to the “OFF” position and turn off the tank valve
Figure 1
1
MAINTENANCE
The flames should look like those in Fig. 12. To clean the burner, use a soft brush after the burner
and lava rocks have cooled completely. Never use a vacuum cleaner on the lava rocks. It is
recommended that the lava rocks be stored indoors during the winter if they will be subjected to
freezing temperatures. The propane cylinder must be disconnected and removed from the appliance
before the appliance can be stored indoors.
Figure 12
