Page 4
ASSEMBLY INSTRUCTIONS
1
2
Attach a table leg to the leg connector bracket by using a 1/4"x15 mm bolt and washer as shown in
. Guide the bolt through the hole in the leg connector bracket, into the pre-drilled hole in the
leg.
Repeat for the other three legs.
F
1
Hand tighten only 2-3 turns.
igure
Place the table top upside down on a flat, non-abrasive surface.
igure
Attach a table leg to the table top by
using four 1/4"x20 mm bolts and washers as shown in
. Guide the bolts through the holes in
the table leg into the pre-drilled holes in the table top.
Repeat for the
other three legs.
F
2
Hand tighten only 2-3 turns.
3
After making any necessary adjustments to the alignment of the table, use the hex bolt driver to tighten
all bolts. Repeat until all bolts are tight.
Over tightening may strip bolts.
Do not over tighten.
F
1
igure
Figure 2
4
With the help of another person, turn the table in the upright position.
A
C
B
FOOT CAP
D
H
F
E
