Page 4
ASSEMBLY INSTRUCTIONS
1
3
After making any necessary adjustments to the alignment of the table, use the hex bolt driver and hex
wrench to tighten all bolts and nuts. Repeat until all bolts are tight.
Over tightening
may strip bolts. Cover all bolts with covers. With the help of another person, turn the table in the upright
position.
Do not over tighten.
F
1
igure
A
Place the table top upside down on a flat, non-abrasive surface. Attach a table leg to the table top by
using two 1/4"x35 mm bolts and Ø20xØ6.5x2.0 mm washers as shown in the
. Guide the
bolts through the holes in the table leg, into the pre-drilled holes in the table top.
Repeat on the other leg.
F
1
Hand tighten 2-3
turns only.
igure
2
B
C
G
E
H
H
D
F
Attach the leg connector bracket to two table legs by using six 1/4"x18 mm bolts and Ø6.5x1.0 mm
washers as shown in the
. Guide the bolts through the holes in the leg connector bracket, into
the pre-drilled holes in the table legs.
F
2
Hand tighten 2-3 turns only.
igure
Figure 2
