4
English
Assembly
(see page 33)
Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal pressures.
Installation Instructions
• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• The fittings must be mounted in an insulated manner
and with sound insulation.
Assembly
(see page 33)
• Install body with G 3/4 outlet pointing downwards.
• Depth of fitting: 68 mm to 96 mm.
• extension set 28 mm
Note: When installation is complete ensure
that the mixer is turned off!
A
Direct wall installation.
B
Direct wall installation with 10 mm adjustable
mounting studs.
C
Brick wall installation.
Technical Data
Operating pressure:
max. 1 MPa
Recommended operating pressure:
0,1 - 0,5 MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 60°C
Thermal disinfection:
70°C / 4 min
Connections Rp 1/2:
cold right - hot left
The product is exclusively designed for drinking water!
Symbol description
Do not use silicone containing acetic acid!
Adjustment
(see page 34)
To adjust the hot water limiter. Using a hot water limiter in
combination with a continuous flow water heater is not
recommended.
Dimensions
(see page 35)
Flow diagram
(see page 35)
free flow
Tub outlet
Shower outlet
Spare parts
(see page 37)
Special accessories
(see page 37)
order as an extra
• extension set 28 mm #32498000
Final assembly
(see page 36)
Summary of Contents for 31741180
Page 33: ...33 A B C...
Page 35: ...35 15 0 89 12 3 80 Rp1 2 90 17 30 5 55 60 Rp3 4 R p 1 2 1 2 1 2...
Page 38: ...38...
Page 39: ...39...
