6
7
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the sink.
3. Slip the plastic washer, the slide washer, the
metall washer and collar nut over the hose and
threaded base and tighten the collar nut by hand.
If there is not enough space, please use only the
slide washer and the metall without the plastic
washer.
4. Tighten screws.
5. Connect the connecting hose to the angle valves;
cold right - hot left.
Large differences in pressure between the hot and
cold water supply should be balanced.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
Technical Data
Operating pressure: max. 10 bars
Recommended operating pressure:1 - 5 bars
Test pressure: 16 bars
Hot water temperature: max. 80° C
Recommended hot water temp.: 65° C
Rate of flow: 11 l/min 3 bars
Single lever mixers can be used together with
hydraulically and thermically controlled continuous
flow heaters if the flow pressure is at least 1.5
bars.
To adjust the hot water limiter on single lever mixers,
please see page 14.
No adjustment is necessary when using a continuous
flow water heater.
English
Spare parts
(see page 3)
1 lever head 14092000
1.1 screw cover 96338000
2 flange 96391000
3 nut 94194000
4 cartridge cpl. 92730000
5 aerator cpl. (10) 13955000
6 fixation cpl. 95049000
7 connection hose 600 mm 96556000
