8
Assembly
Important!
The fitting must be installed, flushed
and tested after the valid norms.
The hot and cold supplies must be of equal
pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
The flow is changed from bath to shower function
by pulling the knob at the upper side of the spout.
After shutting off the water flow, the mixer returns
automatically to the bath function.
Technical Data
Operating pressure:
max. 1 MPa
Recommended operating pressure: 0.1 - 0.5 MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 80° C
Recommended hot water temp.: 65° C
Rate of flow by 0.3 MPa:
approx. 15,3l/min
Anti-pollution function
English
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0.15 MPa.
Spare parts
(see page 3)
1 handle
39091000
2 flange
96671000
3 nut
97157000
4 cartridge cpl.
96339000
5 aerator cpl.
13956000
6 selector assy
97978000
7 diverter knob
96466000
8 hose 1,25 m
28282000
9 filter packing(5)
94246000
10 handshower
28531000
Fault
Cause
Remedy
Insufficient water
- Shower filter seal dirty
- Clean filter seal between shower
and hose
Mixer stiff
- Cartridge defective, calcified
- Exchange cartridge
Mixer dripping
- Cartridge defective
- Exchange cartridge
Instantaneous heater didn’t work - Filters are dirty
- Clean the filter / exchange filter
