7
Assembly see page 60
Fault
Cause
Remedy
Insufficient water
-
Supply pressure inadequate
-
Check water pressure (If a pump
has been installed check to see if
the pump is working).
-
Regulator filter dirty
-
Clean filter in front of the mixer and
on the MTC-thermo cartridge
-
Shower filter seal dirty
-
Clean filter seal between shower
and hose
Crossflow, hot water being forced
into cold water pipe, or vice versa,
when mixer is closed
-
Backflow preventers dirty or leaking
-
Clean backflow preventers, ex-
change if necessary
Spout temperature does not cor-
respond with temperature set
-
Thermostat has not been adjusted
-
Adjust thermostat
-
Hot water temperature too low
-
Increase hot water temperature to
42 ºC to 65 ºC
Temperature regulation not possible
-
thermo cartridge calcified
-
Exchange thermo cartridge
-
For new installations: basic body
incorrectly connected (should be:
cold right, hot left) or installed with
180º rotation
-
Install function block turned through
180º
Safety stop button not operating
-
Spring defective
-
Button calcified
-
Clean spring and/or button, ex-
change if necessary
Valve stiff
-
Select stop valve DN9 damaged
-
Exchange Select stop valve DN9
Shower or spout dripping
-
Select stop valve DN9 damaged
-
Exchange Select stop valve DN9
Pushbutton cannot be actuated or is
without function
-
Safety guard of isolating valve has
not been removed
-
Remove safety guard from isolating
valve
Pushbutton is jammed or stiff
-
Seal needs greasing
-
Grease the seal
Pushbutton does not snap in
-
Select Adapter incorrectly trimmed
-
™ (see page 61)
-
First, fully press the pushbutton
down into the rosette; then, mount
the rosette
Cleaning
(see page 73)
Test certificate
(see page 65)
Spare parts
(see page 72)
XXX = Colors
000 = chrome plated
400 = white/chrome plated
450 = white
600 = black/chrome plated
610 = black
Operation
(see page 71)
Minor leaking may occur briefly during
initial commissioning and interruption/restart
of the water supply.
English
Summary of Contents for ShowerSelect S 1574300 Series
