111
INSTALLATION
Elements
kitchen hood consists of the following elements
(Fig. 2...):
1) Hood body with a glass [C], equipped with lights,
the fan unit and cassette-type metal filters
2) The telescopic masking cover consisting of the
top funnel A and the bottom funnel B,
3) Wall hanger of the top masking cover [E],
4) Air exhaust guide [D],
5) Set of mounting plugs
Installation
To install the hood perform the following operations:
1. Hang the hood body,
2. Connect the hood to the ventilation duct,
3. Establish the height of the telescoping column
of the masking cover,
4. Install the wall hanger at the appropriate level,
5. Install the complete set of masking covers,
6. Connect the hood to the power supply network.
1. Installation of the hood body
a) Trace a vertical line on the wall to indicate the
center of the cooker plate,
b) Dismantle the aluminium grease filter,
c) Hold the hood body [C] to the wall with its cen
-
ter mark on the vertical central line, maintaining
the minimum distance of 650 mm between the
bottom edge of the hood and the cooker plate
(Fig. 2),
d) Indicate the spacing of mounting holes on the
wall (Fig. 3),
e) Drill the holes as indicated on the wall, using
drills of diameter corresponding to the attached
expansion plugs, drive the plugs in and then
screw the hood body to the wall.
f) Install the aluminium grease filter.
2. Installation of the telescopic column of masking
covers
To install the column of masking covers proceed as
follows:
a) Attach the telescoping column of the masking
covers on the mounted hood and extend it to
the required height, indicate on the wall the pla
-
ce for installing the hanger [E] of the top ma
-
sking cover (Fig. 1),
b) Hold the hanger of the top masking cover [E] to
the wall, indicate the mounting holes. Drill the
holes as indicated on the wall, using drills of
diameter corresponding to the attached expan
-
sion plugs [L], drive the plugs in and then screw
the masking cover hanger profile to the wall.
c) Install the column of masking covers again,
extend to the required height and, using the
attached screws, assemble the entire device.
