105
OPERATION AND MAINTENANCE
Use control panel to control your cooker hood (Fig. 4)
- “-” and “+” touch sensors control cooker hood fan speed in the range from 1 to 4,
- “+” touch sensor increases cooker hood fan speed
- “-” touch sensor reduces cooker hood fan speed
- Timer touch sensor activates fan timer (max 90 min.)
- Lights “L” touch sensor switches cooker hood lights on/off independently of fan operation. Press for
a short time to switch on/off lights.
Program function (Timer)
- This cooker hood has a timer function, which controls fan operation. It can be programmed to auto
-
matically switch off the fan after 10 to 90 minutes in 10 minutes intervals.
- In order to activate the timer function set the cooker hood fan at a required speed by pressing the
“+” touch sensor and then touch the timer (clock) touch sensor. The display will show a flashing 0
to indicate that timer setup mode is activated. Now select the delay time to switch off the cooker
hood fan by touching ‘’+‘’, keeping in mind that the number displayed musts be multiplied by the 10
minute interval (For example 1=10 min, 2=20 min,3=30 min, and so on)
- Once the required delay time is set, confirm it by touching the timer (clock) symbol again. The dis
-
play will stop flashing and indicate current fan speed. A small flashing dot by the value correspond
-
ing to fan speed indicates that timer is counting down. To cancel the fan timer function, touch the
timer (clock) sensor while the countdown timer is running.
Note: The timer function must be activated within 20 seconds. If no action is taken the cooker hood will
switch to normal operation mode. Electronics protected with a 250V-1.6 A fuse / quick acting (5x20 glass
fuse-element).
FILTER SATURATION INDICATOR
The cooker hood is equipped with an electronic filter saturation indicator:
- Replace the charcoal filter – „C” is displayed (220 hours of operation),
- Clean the aluminium filter – „F” is displayed (100 hours of operation),
Neither of these indications affects cooker hood operation, however when C or F is shown, fan speed
indication (0 to 4) is not displayed until the „C” or „F” symbol is cleared.
Touch and hold timer sensor field for about 10 seconds to clear the „C” or „F” symbols.
