23
Stop using multi-component detergents
Add special salt and rinse aid to dispensers.
Set the water hardness to the highest level (6) and run an empty dishwasher.
Adjust the water hardness.
Adjust rinse aid setting.
8
Add rinse aid to the dispenser and adjust setting
Use rinse aid to prevent the formation of white water drops, lime scale spots, white
streaks that may occur on the dishes, as well as to improve the drying process. Con-
trary to popular belief, it not only serves to obtain a shiny dishes, but also to facilitate
drying. For this reason, make sure there is always sufficient amount of rinse aid in
the dispenser.
If the rinse aid indicator on the control panel lights up, add rinse aid to the dispenser.
To add rinse aid remove the dispenser lid by unscrewing it. Add rinse aid until the
level indicator becomes dark. Replace the lid and turn it until markings align. Use
rinse aid level indicator to make sure the level is sufficient. Dark colour indicates suf
-
ficient rinse aid level in the dispenser, and the light colour indicates you need to add
rinse aid to the dispenser.
You can adjust rinse aid dosage from 1 to 6. The factory setting for the rinse aid is 4.
Adjust to a higher dose if streaks remain on the dishes after drying or to a lower dose
if blue residue collets on the dishes.
Full
¾ full
½ full
¼ full (add more)
Empty
Remove the rinse reservoir cap by
lifting up the handle.
Pour the rinse aid into
the dispenser, being
careful not to overfill.
Close the cap after all.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is designed to adjust the
consumption by user. Follow the below steps.
1. Open the door and switch on the appliance;
2. Within 60 seconds after step 1, press the Program button more than 5 seconds, and then press the
Delay button to enter the set model, the rinse aid indication blinks as 1Hz frequency.
3. Press the Program button to select the proper set according to your using habits, the sets will chan-
ge in the following sequence: D1->D2->D3->D4->D5->D1. The higher the number, the more rinse aid
the dishwasher uses.
4. Without operation in 5 seconds or press the Power button to exit the set model, the set success.
Summary of Contents for ZIM655H
Page 51: ...10 2020 1 ...
