5
Hot Tub Wave/Control System Installa�on
3
Hot Tub Wave Installa�on
3.1 Filling Hot Tub Wave with water
a
) Fill the Hot Tub Wave through a skimmer (if equipped) to avoid aera�ng the pumps
b)
Do not fill the Hot Tub Wave with water ho�er than 40ºC.
c) When the water reaches the desired level, insert the cartridge filter into the skimmer
3.2 Star�ng the Electric Power Hot Tub Wave
4
Opera�ng
s
yst
em
4.1
Descrip�on of the control system
light
blower
massage
filtration
Please note: the wiring of the Hot Tub Wave must be done according to
the standards in force in the Czech Republic according to ČSN 33 2000-7-70
Fill the Hot Tub Wave with sufficient level of water. Water level in the Hot Tub Wave
must never fall below the level of the skimmer (if equipped). When filling the Hot Tub
Wave with water, you no�ce that water is leaking, stop the filling the Hot Tub
un�l the fault is rec�fied. The Hot Tub Wave does not have so�ening technology and
hard water is harmful to it. For damages that is caused by improper handling,
are not covered by the warranty.
(if equipped). When installing the filter, �lt the filter so that no air bubbles remain.
Only a�er removing the air from the filter, install it in place.
If the Hot Tub Wave is connected with a moving lead, the lead wire must not be (cable)
be subjected to any strain from sharp objects or other influences. In this case,
we recommend placing the lead wire in a protec�ve sleeve (protector).
Install the appropriate circuit breaker for the Hot Tub Wave.
