HANSCRAFT IN.K300, User Manual

11

Control panel

5.5  Program menu

The program menu is accessible by holding down the Lights key for 5 seconds. In the 
program menu the following parameters can be set: clock, filter or purge cycles, 
economy mode and temperature units. While in the program menu, use the Arrow 
Up or Arrow Down key to adjust the parameters and use the Lights key to jump to 
the next parameter. The changes will be saved after the confirmation of the last 
parameter only. If there is no action taken for 10 seconds, the system will exit the 
program menu without saving any changes.

OOf

PM

1248

LIGHT

(hold for 5 seconds)

30 minutes to warn you that the system is about to resume its normal operation. Press 
JETS to restart the system before the expiration of the 30 minute delay. When the 
system resumes its normal operation, the display shows “On” for 3 seconds.

5.6  Setting the clock 

Enter the program menu by holding down the Lights key for 5 seconds. The display 
will show the current clock setting with the hour flashing. “PM” Depending on 
factory settings your system may be set to 24-hour time or 12-hour time. Setting 
the hour: Use the arrow keys to adjust the hour. Press the Lights key to jump to the 
next parameter, the minutes. Setting the minutes: Use the arrow keys to adjust the 
minutes. Press the Lights key to jump to the next parameter, the filter or purge start 
time (FS).

picture on the next page