HANSCRAFT SPATOUCH 3, User Manual

5

Preparation

/

Installation of the hot tub

2 2

Preparation for the interior hot tub installation

If the hot tub is installed in an interior space, it is necessary to comply with safety 
instructions. The basic safety requirements are mainly non-skid floors and drainage 
in the place of the installation in case of a water overflow. It is also crucial to keep 
in mind that the humidity around the hot tub will rise and can damage surrounding 
electric appliances. Therefore we recommend customizing the place of the installation 
according to these conditions. The hot tub should be accessible from all sides for 
future repair services  If it is not sufficiently accessible during the guarantee period, 
the owner has a duty to ensure the access.

2 3  Preparation for the exterior hot tub installation

If the hot tub is installed in an exterior space, it is necessary to comply with safety 
instructions. The basic safety requirements are mainly non-skid floors and water 
drainage in case of a rainfall or water overflow from the hot tub. Therefore we 
recommend customizing the place of the installation according to these conditions.

3  Installation of the hot tub

Warning: connection to electricity must be done according to norms valid in 
Czech Republic ČSN 33 2000-7-701

3 1 

General information

We strongly recommend you to hire professionally trained and qualified technicians for 
the process of installation. If you decide to install the hot tub by yourself, please abide 
by the following instructions.
a)   Carefully remove all the packaging material from the hot tub and position the hot 

tub on a beforehand selected place of installation.

b)  

Demount the front panel on the side of the hot tub control panel. Demount the 
upper cover of an electrical wiring under which you can find a residual current device, 
a ground fault circuit interruptor (if it is part of the hot tub equipment) and a ground 
staple. The connection itself must be done by a person with an expert qualification.

c)   Every hot tub is tested in real life conditions during the production process, 

therefore there is a possibility some technical parts of the hot tub have remained 
slightly dirty. We recommend you to clean the surface of the hot tub using a 
suitable method; lukewarm water works best for this purpose. Clean the surface 
using a soft cloth only. Don't use any rough abrasive means and cloths which could 
permanently damage the surface of the hot tub. If you decide to use a generic 
cleaning detergent, it cannot be aggressive towards the hot tub surface.

d)   Before filling the hot tub, make sure that all the screws on the equipment are 

tightened to prevent water leakage.