HEKS8854F
Setting up the refrigerator
19
8. Close the door of the built-in cabinet and check that the slid-
ing guide between the elbow 11 and the door coupler 9 func-
tion smoothly.
9. A gap of at least 6 mm must be maintained between the
built-in refrigerator and the built-in cabinet door so that the
refrigerator door can close without any problems. To set the
gap width, loosen the screws 13 slightly and manually set the
desired distance. Then tighten the screws 13 again.
7. Screw the door couplers 9 on tight using the screws 13, while
maintaining a gap of approx. 18 mm to the edge of the door
of the built-in cabinet.
18 mm
6 mm
6 mm
10. Open the refrigerator door out as far as possible and push
the long cover strips 10 into the guide rails of the door cou-
plers 9.
11. Place the short cover strips 12 on the elbows
11
as a cover.
12. Cut the joint profile 8 to the appropriate length. Press it in on
the reverse side of the door hinges between the refrigerator
and the built-in cupboard wall.
13. Re-insert the glass shelves 7 and 6, vegetable drawers 5 and
the door shelves 3 and 4 into the refrigerator.
You have successfully installed the refrigerator.
Summary of Contents for 19677946
Page 30: ...HEKS8854F 30 ...
Page 60: ......
