Built-in oven 65M90D0-E11319G
GB-25
Operation
Using the appliance as a
kitchen alarm clock (timer)
1. Press the button
11
for approximately 3
seconds. The power indicator
17
will ap-
pear on the display.
2. Briefly press the button
11
again until the
timer indicator
18
flashes on the display.
3. Press the button
10
or
13
to enter system
setting mode.
4. Set the desired length of time as described
in steps 4-6 under “Setting a cooking time”.
5. Briefly press the button
11
again.
88 88
A
14 45
A
The display will now show the current time,
as well as the power indicator
17
and the
timer indicator
18.
Once the set time has
elapsed, an acoustic signal will sound, and
the timer indicator
18
will flash.
Please note!
• Following the set time, the appliance will
not
automatically switch to standby mode.
To put it into standby mode, press the
button
11
and the button
13
simul-
taneously for approximately 3 seconds.
Deleting programmed settings
To delete a set cooking time and/or end time,
• press the button 11 and the button 13
simul taneously for approximately 3 seconds.
Pausing the programme
To pause a programme (cooking time, end time)
in progress,
• press the button 11 and the button 13
simul taneously for approximately 3 seconds.
Pausing the acoustic signal
The acoustic signal you will hear at the end of a
set cooking time normally lasts approximately 2
minutes. You can pause this acoustic signal at
any time:
• Briefly press any button (for fewer than 3
seconds).
Summary of Contents for 268 880
Page 72: ......
