Operation
Page EN-11
The control panel
(10) Sensor for turning the appliance
on/off
(11) Sensor for turning the beeping
sound on/off
(12) Sensor for selecting the
temperature zone (upper/lower)
(13) Sensor for selecting the
temperature indicator (actual/target)
(14) Temperature indicator for the
temperature zone (upper)
(15) Temperature indicator for the
temperature zone (lower)
(16) Sensor for increasing the
temperature
(17) Sensor for reducing the
temperature
(18) Sensor
C
F
for changing the
temperature unit (Celsius/Fahrenheit)
(19) Sensor for turning the lighting
on/off
Before getting started
• Read the “Safety” chapter from
page EN-4.
• Set up and connect the appliance as
described in chapter “Start-up” from
page EN-18.
Signal tones
Each time you press one of the sensors num-
bered (10) to (13) and (16) to (19), you will
hear a beep. This tells you that the appliance
has registered your input.
• Touch the sensor
(11) to switch the
beeping sound on or off.
Touch any one of the sensors on the
control panel to deactivate the alarm in
the event of a malfunction.
Switching the appliance on
and off
Switching on for the first time
• If you have not already done so, insert the
mains plug into an easily accessible and
properly installed socket (220–240 V~ /
50 Hz).
The temperature indicators (14) and (15)
will show the current internal temperatures,
– left for the upper zone,
– right for the lower zone.
You will hear the compressor start to work,
and the appliance will begin cooling.
The appliance is switched on.
C
C F
22
C
23
C
(18)
(17)
(16)
(14)
(15)
(12)
(11)
(13)
(19)
(10)
Operation
