Operation
Page GB-12
Before getting started
– Read chapter "Start-up“ from page GB-25
and all the safety notices.
– Set up and connect the appliance as de-
scribed in chapter "Start-up“ on page GB-25.
Switching the appliance on
and off
NOTICE
Risk of damage!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
■
Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting.
Switching on
1. Insert the mains plug into an easily acces-
sible socket (220-240 V~ / 50 Hz).
– On the control panel the temperature
signals (16) and (17) will light up.
– When you open one of the appliance
doors, the interior of the appliance is lit
up.
– The compressor starts to work, the re-
frigerant flows through the pipes and a
quiet humming sound can be heard. The
appliance is switched on.
2. If the appliance makes worrying noises
check the solid base and remove any ob-
jects that are on top of the appliance.
Operation
Switching off
1. Disconnect the mains plug from the socket.
– The signals on the control panel go out.
– When you open one of the appliance
doors, the lights inside the appliance (1)
remain switched off.
– The compressor is switched off. The ap-
pliance doesn’t refrigerate.
2. Empty the appliance and clean it (see
"Care and maintenance“ on page GB-22).
3. Leave the appliance doors slightly open
to prevent mould from forming.
Locking/unlocking the control
panel
LOCK/UNLOCK
HOLD 3S UNLOCK
REF.TEMP.
LOCK
(21)
(20)
S U
S U
The fridge-freezer is protected against unin-
tentional changes in settings. The
LOCK
sym-
bol lights up on the display. If any button is
pressed you will hear a beeping sound and
the (21)
LOCK
signal will flash. The control pan-
el is locked.
Unlocking
• Press the LOCK/UNLOCK button (20)
down for 3 seconds. The symbol lights
up and a beep sounds. The control panel
buttons are now released.
Locking
• Press the LOCK/UNLOCK button (20)
down for 3 seconds.
You will hear a beeping sound and the
LOCK
symbol will appear on the display.
If no button is pressed for 25 seconds,
the control panel will lock automatically.