Page EN-28
Fitting and installation
560 to 564
490 to 494
50
50
(Measurements in mm)
2. If a hob was already installed, the cut-out
section must be no larger than:
560
up to 574 mm wide
490
up to 494 mm deep.
Attach rails!
574
560
7
7
490
(Measurements in mm)
3. Attach adjustment strips to the left and to
the right of the worktop in order to achieve
the width of 560 mm.
4. Seal the cut surfaces with a special var-
nish, silicone sealant or cast resin to pre-
vent swelling caused by moisture.
Preparing and inserting the hob
NOTICE
Risk of breakage!
■
Do not place the hob on the glass ce-
ramic edge!
1. Take the hob out of the packaging.
2. Remove all protective films and adhesive
tapes.
3. Turn the hob over and place it with the
glass side down on a soft surface.
4. Stick the supplied plastic strip onto the
lower-lying edge.
5. Carefully place the hob (residual heat in-
dicators at the front) in the middle of the
worktop cut-out.
Thin worktop
Summary of Contents for 65C90C7-E11B000
Page 42: ...Technische Daten Seite DE 42...
