EN-14
HFD17690EI
Preparing the appliance
Levelling the combination
fridge-freezer
The combination fridge-freezer must be stood
on a firm, flat surface. Check the position of
the combination fridge-freezer, preferably with
a spirit level. The combination fridge-freezer
should not move when the doors are opened.
Adjusting for floor unevenness
Unevenness in the floor surface can be levelled
out using the front two feet.
1. Close doors.
2. Tip the combination fridge-freezer back-
wards slightly.
3. Screw in or unscrew the feet until the com-
bination fridge-freezer is vertically aligned.
4. Stand the combination fridge-freezer upright
again and use a spirit level to check that it
is level.
Closing the fridge door
NOTICE
Risk of damage!
Improper handling of the combination
fridge-freezer may lead to damage.
• Do not adjust the fastener bar on the
left-hand fridge door.
13
To prevent the loss of cold air, the left-hand
fridge door is equipped with a fastening bar
13
.
When the door is closed, it automatically hinges
over and locks both fridge doors. It is normal for
the fastening bar
13
to get warm.
Adjusting the doors
It may be that the doors are not on the same
height, even if the fridge-freezer itself is com-
pletely level. In this case you can adjust the
position of the doors by raising the one that is
lower.
1. Open the door and lift it up. This will create
a gap between the bottom door hinge and
the door.
2. Insert the supplied attachment ring into the
gap.
3. Close the door.
4. Check the position of the doors and insert
more attachment rings if necessary.
