Page EN-10
Operation
Requirements for safe use
– You have read chapter “Safety” from page
EN-4 and understand all the safety notices.
– The appliance is set up and plugged in as
described in chapter “Start-up” from page
EN-16.
Switching the appliance on
and off
NOTICE
Risk of damage!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
■
Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting.
Switching on
• Insert the mains plug into an easily acces-
sible socket (220–240 V~ / 50 Hz). The
temperature indicator (12) will light up.
The appliance is switched on.
Switching off
1. Disconnect the mains plug from the socket.
The temperature indicator (12) will go out.
The compressor is switched off. The ap-
pliance doesn’t refrigerate.
2. Empty the appliance and clean it (see
“Care and maintenance” on page EN-14).
3. Leave the glass door (3) slightly ajar to
prevent mould from forming.
Controlling the temperature
The current interior temperature can be read
from the temperature indicator (12) while in
operation.
Operation
If you want to control your temperature set-
ting,
• press the SET function button (11) once.
The appliance will beep and the temper-
ature indicator (12) will flash the set tem-
perature.
Setting the temperature
WARNING
Health hazard!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
■
Always ensure the prescribed ambi-
ent temperature is maintained (see
“Intended use” on page EN-4).
Use the control element (2) to set the appli-
ance’s inside temperature.
Select the right temperature based on the
wine. Further information on the optimum
storage temperature can be found in the sec-
tion “Maintaining quality” on page EN-13.
You can choose settings ranging from +4°C
to +22°C.
1. Press the SET function button (11) once.
The appliance will beep and the tempera-
ture indicator (12) light will begin to flash.
2. As long as the temperature indicator is
flashing, you can set the temperature.
– Decreasing the temperature:
Push the button (13) until the desired
temperature appears.
– Increasing the temperature:
Push the button (7) until the desired
temperature appears.
If you hold down the or but-
ton, the temperature indicator will
automatically scroll through the tempera-
ture settings.
