Start-up
Page EN-31
Electrical connections
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■
Do not operate or continue to oper-
ate the appliance, if it
–
shows visible signs of damage, e.g.
the mains cable is defective,
–
starts smoking or there is a smell of
burning,
–
makes unfamiliar noises.
In such cases, remove the mains plug
from the socket or unscrew/isolate
the fuse and contact our service de-
partment (see page EN-34).
■
When positioning the appliance, en-
sure the supply cord is not trapped
or damaged. Do not kink the supply
cord or lay it over sharp edges. This
can result in a break in the cable.
■
Do not put portable multi sockets or
mains adapters at the rear of the ap-
pliance.
■
Since all poles of the appliance can-
not be disconnected from the mains
via an accessible disconnecting de-
vice, an all-pole disconnecting device
in accordance with overvoltage cate-
gory III must be connected within the
house installation with at least 3 mm
contact clearance; consult a qualifi ed
professional if necessary (see “Ser-
vice” on page EN-34).
CAUTION
Fire hazard!
Improper handling of the appliance can
lead to fi re and damage to property.
■
Connect the appliance only to a
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage to property!
If the cooling appliance has been trans-
ported horizontally, lubricant from the
compressor may get into the cooling
circuit.
■
If possible, do not tilt the cooling ap-
pliance horizontally.
■
Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Insert the mains plug into an easily ac-
cessible and properly installed socket
(220–240 V~ / 50 Hz).
You will find all important information
about operation from page EN-12.
Summary of Contents for HCDB18080DWDI
Page 40: ......
