Start-up
Page GB-23
Installing the appliance
Before installation, check that the door
hinges are on the correct side. Change
the position of the door hinges if necessary
(see „Changing the door hinges“ on page
GB-20).
For installation, you will need a PH2 cross-tip
screwdriver.
1. Switch off the fuse for the intended sock-
et (220-240 V~ / 50 Hz). Then insert the
mains plug into the socket.
2. Slowly and carefully push the refrigerator
into the built-in cabinet. Make sure that
the side to be opened is as close as pos-
sible to the wall of the cabinet.
(17)
(12)
(14)
3. There are holes pre-drilled in the out-
side edges of the appliance door for the
slides (12) to be attached.
Use screws (17) to attach 2 sliders each
per door on the sides to be opened.
4. Push the runners (14) into the slides.
Close and open the cabinet door to
check that it closes fully and easily. If
necessary, correct the position of the
refrigerator.
5. Open the appliance door and cabinet
door at the same time. As you do so,
mark the best position for the runners on
the inside of the cabinet door.
(17)
(14)
6. Remove the runners from the slides
again.
7. Use two screws to fasten each of the
runners to the inside of the cabinet door
in the marked positions.
(15)
8. Press the covers (15) onto the runners.
9. Unscrew the slides again and push them
onto the fitted runners.
10. Screw the slides back onto the appliance
door.
Summary of Contents for HEKS 14454GA2
Page 60: ...Technical specifications ...