Start-up
Page EN-28
Installing the appliance
Before installation, check that the door
hinges are on the correct side. Change
the position of the door hinges if necessary
(see “Changing the door hinges” on page
EN-25).
For installation, you will need a PH2 cross-tip
screwdriver.
1. Switch off the fuse for the intended sock-
et (220–240 V~ / 50 Hz). Then insert the
mains plug into the socket.
2. Slowly and carefully push the refriger-
ating appliance into the built-in cabinet.
Make sure that the side to be opened
is as close as possible to the wall of the
cabinet.
(23)
(18)
(20)
3. There are holes pre-drilled in the out-
side edges of the appliance door for the
slides (18) to be attached. Use the short
screws (23) to fasten the slides on the
side that is to be opened.
4. Push the runners (20) into the
slides (18). Close and open the cabinet
door to check that it closes fully and eas-
ily. If necessary, correct the position of
the refrigerating appliance.
5. Open the appliance door and cabinet
door at the same time. As you do so,
mark the best position for the runners on
the inside of the cabinet door.
(23)
(20)
6. Remove the runners from the slides
again.
7. Use 2 short screws (23) to fasten each
of the runners to the inside of the cabinet
door in the marked positions.
(21)
(20)
8. Press the covers (21) onto the runners.
9. Unscrew the slides again and push them
onto the fitted runners.
10. Screw the slides back onto the appliance
door.
