Dispensing cold water and ice
Page EN-23
Using the ice maker
The production of ice cubes creates noise.
The water vent hums. Water flows into the ice
tray. Finished ice cubes fall into the ice cube
container. These noises are normal.
When ice cubes are dispensed, there may be
loud cracking noises. This is also not a cause
for concern.
(34)
It is possible that ice cubes have stuck to-
gether in the ice cube container (34). In this
case:
1. Remove the ice cube container (34).
2. Divide the fused ice cubes, for example
by carefully pushing on them with a plas-
tic or wooden spoon.
3. Remove ice cube clumps.
4. Divide the ice cubes evenly in the ice
cube container (34).
Other options are described in section “Clean-
ing the ice cube container“ on page EN-26.
In order to avoid overheating the ice maker’s
motor, the dispensing of ice will stop after
about 1 minute. In this case, wait a moment
until the motor has returned to operating tem-
perature.
If there are not enough ice cubes in the ice
cube container, it may not be possible to dis-
pense any ice. If this is the case, please wait
until fresh ice cubes are produced.
In order to prevent unpleasant odours or fla-
vours from developing in the ice cubes, clean
the ice cube container (34) on a regular basis.
Activating and deactivating
the ice maker
Super
Filter Reset 3s
Ice On
Freezer
°C
– 18
(30)
(18)
• To activate the ice maker, press the ‘Ice
On’ button (18).
The symbol (30) will appear on the dis-
play.
• To deactivate the ice maker, press the ‘Ice
On’ button (18) again.
The symbol (30) will disappear from the
display.
Dispensing ice cubes
• Remove ice cubes from the ice cube con-
tainer (34) in the upper freezer drawer (4),
using the ice cube spade.
