Start-up
Page EN-34
(46)
(44)
(38)
(40)
5. Hand-tighten the ¾ inch screw con-
nector (46) onto the tap with the check
valve (44).
6. Insert the hose (38) between the water
inlet and water filter as far as possible into
the check valve (44) and firmly attach the
hose with a blue safety clip (40).
(35)
(37)
(39)
7. Insert the end of the hose (35) between
the water filter and appliance as far as it
will go into the water filter’s outlet side.
8. Use a red safety clip (39) to firmly attach
the hose (35) to the water filter.
Make sure that the hose is firmly
inserted into the water filter so that
there are no leaks.
Do not kink or pinch the hose or lay it over
sharp edges.
9. Open the water valve for 5 minutes to
flush the filter before use.
The initial dark discoloration of water
is normal.
Connecting the filter to the appli-
ance inlet
The appliance hose is located on the back
of the appliance.
(48)
(49)
(35)
(42)
1. Remove the cap (48) from the appliance
hose (49).
(49)
(35)
(48)
(42)
2. Insert the end of the appliance
hose (49) and the end of the hose (35) as
far as possible into the hose coupling (42)
between the water filter and appliance.
