First use
Page EN-23
CAUTION
Fire hazard!
Improper handling of the appliance can
lead to fire and damage to property.
■
Connect the appliance only to a
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage to property!
If the cooling appliance has been trans-
ported horizontally, lubricant from the
compressor may get into the cooling
circuit.
■
If possible, do not tilt the cooling ap-
pliance horizontally.
■
Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to flow
back into the compressor.
• Insert the mains plug into an easily ac-
cessible and properly installed socket
(220–240 V~ / 50 Hz).
You will find all important information
about operation from page EN-10.
Changing the door hinges
If your spatial conditions require it, you can
change the door hinge of the appliance
door (2). This work, however, requires you to
have a certain degree of craftsmanship skills.
In addition to the package contents, you will
also need the following material to change
the door hinge:
– Medium size cross-tip screwdriver
– Medium slotted screwdriver
– Potentially an 8 mm and 10 mm spanner
• Please read through all of the following
steps before starting work.
Removing the appliance door
(17)
(18)
(21)
(20)
(19)
1. Remove the hinge cover (17) of the upper
hinge (18) and the opposite cover (19).
2. Use the cross-tip screwdriver or the 8 mm
spanner to loosen the screws (20) and re-
move the upper hinge.
3. Lever out the blind plug (21).
4. Remove the appliance door (2) and set
it aside.
5. Tilt the appliance so that you can reach
the lower hinge with the cross-tip screw-
driver or the 8 mm spanner.
