HGS14355EW, HGS14355ES
HGS14355EW, HGS14355ES
Unpacking and set-up
EN-11
Unpacking and set-up
EN-11
If these distances cannot be maintained, put an insulating plate
in between. If there is underfloor heating in the room where the
freezer is to be installed, place an insulating plate of solid material
underneath the appliance.
– To ensure sufficient air circulation, do not place the freezer di-
rectly against the wall.
About climate categories
• Always ensure the prescribed ambient temperature is main-
tained (see „Intended use“, page EN-4).
Climate category means that the appliance is intended for opera-
tion at the specified ambient temperature (see table ‘Climate cate-
gories’). If the room temperature drops significantly below this, the
unit will not switch on as often. This indicates that an unwelcome
increase in temperature may occur.
Positioning the freezer
The freezer must stand on a level, solid surface. For the best result,
check the position of the appliance with a spirit level. When you
open the door, the freezer should not move. You can balance out
unevenness in the surface with the two front adjusting feet.
1. Close the freezer door.
2. Tilt the freezer backwards slightly.
3. Screw/unscrew the screw feet as required.
4. Stand the freezer straight up once again and check its align-
ment with a spirit level.
5. Repeat these steps until the freezer is level.
“Climate categories” table
Zone description
Code
Definition
Extended temperate zone SN
This refrigerator is designed for use at ambient temperatures
of +10 °C to +32 °C.
Temperate zone
N
This refrigerator is designed for use at ambient temperatures
of +16 °C to +32 °C.
Subtropical zone
ST
This refrigerator is designed for use at ambient temperatures
of +16 °C to +38 °C.
Tropical zone
T
This refrigerator is designed for use at ambient temperatures
of +16 °C to +43 °C.
Summary of Contents for HGS14355EW
Page 26: ...HGS14355EW HGS14355ES DE 26...
