Operation
Page EN-10
Requirements for safe use
– You have read chapter „Safety“ from see
EN-5 and understand all the safety notices.
– The appliance is set up and plugged in as
described in chapter „Start-up“ from see
EN-18.
Switching the appliance on
and off
(1)
(4)
(2)
(3)
(6)
(5)
Switching on
1. Press and hold down the on/off button (6)
for approximately 3 seconds.
The interior lighting (19) will light up and
the temperature display (2) will appear.
The appliance is switched on.
The compressor starts to work, the refrig-
erant flows through the pipes and a quiet
humming sound can be heard.
2. If the appliance makes worrying noises,
check the solid base and remove any ob-
jects that are on top of the appliance.
Switching off
1. Press and hold down the on/off button (6)
for approximately 3 seconds.
The interior lighting (19) will light up and
the temperature display (2) will disappear.
The compressor is now switched off. The
appliance doesn’t refrigerate.
2. Empty the appliance and clean it (see
„Care and maintenance“ on page EN-16).
3. To switch off the appliance entirely, dis-
connect the mains plug from the socket or
switch off / unscrew the fuse.
Operation
4. Leave the door open slightly to avoid
mould formation.
Setting the temperature
WARNING
Health hazard!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
■
Always abide by the prescribed ambi-
ent temperature (see ‘Climate cate-
gories’ on see EN-28).
Using the buttons (4) ‘Increase temperature’
and (5) “Decrease temperature” you can set
the temperature in the appliance. The tem-
perature display (2) shows the set temper-
ature.
You have a choice of temperatures of be-
tween -16°C to -24°C. The temperature pre-
set by the manufacturer is -18°C.
• First select a medium setting.
• If, for example in summer, the ambient
temperature increases, so select a lower
setting accordingly.
To set
– the temperature higher, press the ‘Increase
temperature’ button (4) until the desired
temperature is displayed.
– the temperature lower, press the ‘Decrease
temperature’ button (5) until the desired
temperature is displayed.
The setting takes effect automatically after
3 seconds.
You ideally need a freezer thermometer to be
able to control the cooling efficiency.
• Place the freezer thermometer in one of
the large freezer drawers (13); the ideal
storage temperature is -18°C.
