Start-up
Page EN-21
(15)
4. Level out any unevenness on the ground
using the two front screw feet (15).
– Close the door.
– Tilt the appliance backwards slightly and
screw/unscrew the screw feet.
– Stand the appliance back up again and
check the alignment with a spirit level.
– Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the door.
Cleaning before use
To remove the odour that comes with all new
appliances, clean the appliance before using
it (see “Cleaning” on page EN-18).
Connecting the appliance
NOTICE
Risk of damage!
If the appliance has been transported
horizontally, lubricant from the com-
pressor may make its way into the cool-
ing circuit.
■
Do not tip the appliance to a horizon-
tal position; transport it at a maxi-
mum incline of 45°.
■
Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Insert the mains plug into an easily acces-
sible socket (220–240 V~ / 50 Hz).
You will find all important information
about operation from page EN-11.
