Start-up
Page GB-9
Start-up
CAUTION
Risk of injury!
■
The appliance is heavy and bulky.
During transport, when setting up
and positioning the appliance, get
help from another person.
■
Freezer baskets, doors, etc. must not
be used as steps or for support pur-
poses.
Health hazard caused by refrigerant!
■
Do not damage the refrigeration cir-
cuit, for example by piercing the re-
frigerant channels of the condensate
vaporiser with sharp objects, cutting
off the tubing, etc.
■
Refrigerant is fl ammable when spurt-
ing out and can damage the eyes. In
this case, rinse your eyes in clean wa-
ter and seek medical assistance im-
mediately.
■
To prevent the formation of a fl am-
mable gas-air mixture in the event of
a leakage in the refrigeration circuit,
the installation space must have a
minimum size of 1 m³ per 8 g of re-
frigerant in compliance with the EN
378 standard. The amount of refrig-
erant contained in your appliance
can be found in the technical data
(see from page GB-23).
■
Do not place heat-emitting applianc-
es such as microwaves, toasters etc.
on the appliance and do not operate
any electrical appliances inside the
appliance.
NOTICE
Risk of damage!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
■
Abide by the specifi ed ambient tem-
perature (see “climate category” on
page GB-23).
Improper handling of the appliance
may result in damage.
■
If possible, do not tip the appliance
horizontally, but transport it at a
maximum inclined angle of 45°.
■
Do not use sharp objects when un-
packing and removing the protective
fi lm.
Transport and unpacking
• Tape the castors under the chest freezer
with adhesive tape to ensure stability dur-
ing transport.
• Transport the chest freezer using a trolley
or with the help of a second person.
• Remove the adhesive strips from the cas-
tors. Lift the chest freezer slightly onto its
left side and push or pull it until it reaches
the desired position.
• Unpack the chest freezer and carefully
remove all packaging, plastic moulding,
adhesive strips and foam padding from
the inside, outside and back of the chest
freezer.
Summary of Contents for HGT 8566A2L
Page 32: ......
