Safety
Page EN-9
evaporator or cause the evaporator
to detach from its holder.
■
Do not pull or lift the appliance by
the appliance doors or door handles.
■
Place the appliance only on a lev-
el and fi rm surface that can support
the weight of the appliance when it
is fi lled.
■
Do not use sharp or pointed objects
to unpack it.
■
When unpacking the appliance, nev-
er damage the insulation material on
the back of the appliance.
■
Do not use mechanical devices or oth-
er means to accelerate the defrost-
ing process, other than those recom-
mended by the manufacturer.
■
The interior light must only be used
to illuminate the interior of the appli-
ance. It is not suitable for lighting a
room.
■
When cleaning, please note:
–
Never use harsh, granular, soda,
acid, solvent-based or abrasive
cleaners. These attack the plastic
surfaces. All-purpose cleaners with
a neutral pH are recommended.
–
Door seals and plastic parts are
sensitive to oil and grease. Remove
contaminants as quickly as possi-
ble.
–
Use only soft cloths.
■
Wait 5 minutes after switching off.
Only then switch the appliance on
again.
■
Only use original accessories.
If the cooling appliance has been trans-
ported horizontally, lubricant from the
compressor may get into the cooling
circuit.
■
If possible, only transport the cooling
appliance in a vertical position.
■
Allow the cooling appliance to stand
upright for two hours before starting
it up. The lubricant will fl ow back into
the compressor during this time.
